This command shows following dialog box:
Select the correct cuting parameters according to your machine
setup. Chnages in here will affect the speeds and report
calculations.
This is the actual "tool diameter" used as default when IGEMS
calculates the tool radius compensation. It is also default
value for the part distance when using commands for common
cutline. If the checkbox "Use mixing tube" is active then the
tool diameter automatically is the same as the diameter of the
mixing tube.
VOC ( variable offset control )
This option makes the toolcompensation change depending on
speed.
The "Pressure" value should be the pressure the pump is set to
(the pressure loss is handled by IGEMS).
All these settings are used in the mathematical formula to
calculate the cutting speed.
Click the "Question mark" button to have some hints of good
combinations of Nozzle/Orifice/Abrasive.
Where do I select the parameters I want to use?
When you select machine and material in the "select" command
then you also select cutting parameters.